2 Installing Device

This chapter describes the specific operations for installing the device.

2.1 Installing Raspberry Pi 5 (optional)

If the product model purchased by the customer does not include Raspberry Pi 5, Raspberry Pi 5 needs to be installed first.

Preparation：

  • ED-HMI3010-101C and Micro SD card have been obtained from the packaging box.
  • Raspberry Pi 5 is ready.
  • A cross screwdriver has been prepared.

Steps：

  1. Insert the Micro SD card into Micro SD card slot of Raspberry Pi 5.
image-20240727121046246
  1. Use a screwdriver to loosen 4 M3 screws on ED-HMI3010-101C case counterclockwise, and remove the case.
image-20241212143749423
  1. Use a screwdriver to loosen 4 M2.5 screws on passive cooler counterclockwise, and remove the passive cooler.
image-20241212143844002
  1. Remove the film of thermal conductive silicone.
image-20241212144001777
  1. Place the Raspberry Pi 5 on the back of the LCD screen so that the mounting holes of the Raspberry Pi 5 can align with the four stud holes on the back of the LCD screen.
image-20241212144028281
  1. Pass the FPC cable through the reserved hole on the passive cooler, insert it into the CAM/DISP1 port on the Raspberry Pi 5, and then place the passive cooler on the Raspberry Pi 5 (make sure the four mounting holes of the passive cooler are aligned with 4 mounting holes of Raspberry Pi 5).
hmi3010-101c-install6-en

TIP

Here we only take installing Raspberry Pi 5 on an LCD screen without CAM interface as an example.

  1. Insert the mounting screws of the Raspberry Pi 5 into the mounting holes of the passive cooler and tighten clockwise to fix the passive cooler and Raspberry Pi 5 on the back of the LCD screen.
image-20241212144355999
  1. Plug the power cord into the corresponding 40-Pin on the Raspberry Pi 5.
njhg78
  1. Cover the case, insert 4 M3 screws, and tighten clockwise to fix the case to the back of the LCD screen.
image-20241212144519634

2.2 Embedded Installation

ED-HMI3010-101C device supports embedded front installation, which is equipped with a Mounting Kit (including 4 x buckles, 4xM4*10 screws and 4xM4*16 screws).

Preparation：

  • A Mounting Kit (including 4 x buckles, 4xM4*10 screws and 4xM4*16 screws) have been obtained from the packaging box.

  • A cross screwdriver has been prepared.

Steps：

  1. Ensure the opening size of the cabinet according to the size of ED-HMI3010-101C, as shown in the figure below.
image-20240722170741016
  1. Drill a hole on the cabinet according to the hole size of step1.
  2. Embed the ED-HMI3010-101C into the cabinet from the outside.
image-20241212144617401
  1. Align the screw hole (unthreaded hole) of the buckle with the buckle installation hole on the device.
image-20240722170759983
  1. Use 4 M4*10 screws to pass through the buckle and tighten it clockwise to fix the buckle to the device; then use 4 M4*16 screws to pass through the screw hole (threaded hole) of the buckle and tighten clockwise to the end through the buckles.
image-20240727140348969