3 Installing Device

This chapter introduces how to install the device.

3.1 Embedded Installation

ED-HMI2220-070C device supports ​front embedded installation. The standard packaging includes the embedded installation Mounting kit (ED-ACCHMI-Front).

Preparation:

  • The ​ED-ACCHMI-Front Mounting kit has been acquired (includes ​4 × M4*10 screws, ​4 × M4*16 screws, and ​4 buckles).
  • A cross screwdriver has been prepared.

Steps:

  1. Determine the cutout dimensions on the cabinet based on the ED-HMI2220-070C’s size, as shown in the figure below.

    Unit: mm

image-20240627140931694

  1. Drill a hole on the cabinet according to the aperture size defined in Step 1.

  2. Embed the ED-HMI2220-070C into the cabinet from the exterior side.

image-20240627141032188
  1. Align the screw holes (non-threaded) of the buckles with the buckle mounting holes on the device side.
image-20240627141100231
  1. Insert four M4*10 screws through the unthreaded holes of the buckle. Tighten clockwise with a screwdriver to secure the buckle to the device. Then, insert four M4*16 screws through the threaded holes of the buckle. Press them against the inner surface of the cabinet chassis and drive clockwise with a screwdriver until full thread engagement is achieved.
image-20240627141129360