3 Installing Device

This chapter introduces how to install the device.

3.1 Embedded Installation

ED-HMI2120-101C supports embedded front installation, which is equipped with a Mounting Kit (including 4 x buckles, 4xM4*10 screws and 4xM4*16 screws) .

Preparation:

  • A Mounting Kit (including 4 x buckles, 4xM4*10 screws and 4xM4*16 screws) have been obtained from the packaging box.
  • A cross screwdriver has been prepared.

Steps:

  1. You need ensure the opening size of the cabinet according to the size of ED-HMI2120-101C, as shown in the figure below.

    Unit: mm

image-20240628141800085

  1. Drill a hole on the cabinet according to the hole size of step1.

  2. Insert the ED-HMI2120-101C into the cabinet from the outside.

image-20240628141918880
  1. Align the screw hole (unthreaded hole) of the buckle with the buckle mounting hole on the side of the device.
image-20240628141952887
  1. Use 4 M4*10 screws to pass through the buckle and tighten it clockwise to fix the buckle to the device; then use 4 M4*16 screws to pass through the screw hole (threaded hole) of the buckle and tighten clockwise to the end through the buckles.
image-20240628142023307