Features
| Passive Cooler for Raspberry Pi 5 |
| Sheet metal + CNC cutting process, easy to install |
| Pre-installed with thermal conductive silicone |
| Excellent cooling performance can effectively reduce the CPU temperature of Raspberry Pi 5 |
| All interfaces of Raspberry Pi 5 are accessible |
Specifications
| Cooling Performance | ||
| Test Device Configuration | Raspberry Pi 5 | Raspberry Pi 5 + ED-Pi4PCOOLER |
| Software Configuration | CPU 4 cores running at full load via sysbench | |
| Ambient Temperature | 25℃ | |
| Stable running temperature of CPU(℃) | 84.5 | 69.6 |
| Test Results: Under the environment of 25℃, when the device is running in a stable state, ED-Pi5PCOOLER can reduce the temperature of Raspberry Pi 5 by about 15℃, allowing the Raspberry Pi 5 CPU to run continuously at its maximum mains frequency (2400MHZ). | ||
| Mechanical Characteristics | |
| Dimensions | 65mm x 58mm x 9.3mm |
| Material | Sheet Metal |
| Colour | Black |
| Weight | About 40g |
Document Download
|
Datasheet Download Testing Report Download |
Dimension Unit:mm
Order Information
| P/N: ED-Pi5PCOOLER |
| Configuration: Passive Cooler for Raspberry Pi 5 |
| Packing List |
|
1 x ED-Pi5PCOOLER
1 x Accessory Kit (With 4 x M2.5*12 Screws and 4 x M2.5 Nuts)
|
Installation Schematic
| Parts list: | ||
| NO. | Name | Quantity (PCS) |
| 1 | ED-Pi5PCOOLER | 1 |
| 2 | Raspberry Pi 5 (Not provided) | 1 |
| 3 | M2.5*12 Screw | 4 |
| 4 | M2.5 Nut | 4 |
|
Note:
- Raspberry Pi 5 is not included in the box, the following is intended as an installation illustration only.
- Before you start installing, please remove the White Protective Paper from thermal silicone in ED-Pi5PCOOLER.
- Before you start installing, please check whether the tops of 4 Nylon Posts in ED-Pi5PCOOLER are on the same level. If there are some tops that are higher than others, please press the higher tops into the mounting holes.
① Place the ED-Pi5PCOOLER on the Raspberry Pi 5 so that the 4 Nylon Post holes align with the 4 mounting holes on the Raspberry Pi 5.
② Place 4 M2.5 nuts under the 4 mounting holes of the Raspberry Pi 5, then insert 4 M2.5*12 screws into the 4 screw hole positions of the ED-Pi5PCOOLER, and use a screwdriver to tighten them clockwise to secure the ED-Pi5PCOOLER to the Raspberry Pi 5.
|
