Features
| Passive Cooling Open Aluminum CNC Case for Raspberry Pi 4 |
| High quality and beautiful open case by aluminum CNC cut, oxidized surface finish |
| Both top and bottom case provide passive cooling for Raspberry Pi 4 though thermal pads & aluminum body |
| Excellent cooling performance can effectively reduce the CPU temperature of Raspberry Pi 4 |
| All interfaces of Raspberry Pi 4 are accessible |
Document Download
Datasheet DownloadSpecifications
| Cooling Performance | ||
| Test Device Configuration | Raspberry Pi 4 | Raspberry Pi 4 + ED-Pi4Case-OB |
| Software Configuration | CPU 4 cores running at full load via sysbench | CPU 4 cores running at full load via sysbench |
| Ambient Temperature | 25℃ | 25℃ |
| Stable running temperature of CPU(℃) | 81.9 | 56.5 |
| Test Results: Under the environment of 25℃, when the device is running in a stable state, ED-Pi4Case-OB can reduce the temperature of Raspberry Pi 4 by about 25℃, allowing the Raspberry Pi 4 CPU to run continuously at its maximum mains frequency (1800MHZ). | ||
| Mechanical Characteristics | ||
| Dimensions | Top Cover: 65mm x 56.5mm x 5mm, Bottom Cover: 88.5mm x 56.5mm x 5mm | |
| Material | Sheet Metal (Top Cover) + Aluminum Profile (Bottom Cover) | |
Dimension Unit:mm
Order Information
|
P/N: ED-Pi4Case-OB
|
| Configuration: Black Passive Cooling Open Aluminum CNC Case for Raspberry Pi 4 |
Packing List
|
1 x ED-Pi4Case-OB Top Cover
|
| 1 x ED-Pi4Case-OB Bottom Cover (4 x pads have been installed) |
|
1 x Accessory Set (With 3 x M2.5*11 screws, 1 x M2.5*4 screw and 1 x 1.5mm allen key)
|
Installation
|
Note：
1.Before you start installing, please remove the White Protective Paper from thermal silicone in the case.
2.Before you start installing your Raspberry Pi 4, please check whether the tops of 3 nylon posts in the top cover are on the same level. If there are some tops that are higher than others, please press the higher tops into the mounting holes.
①Align Raspberry Pi 4 with the reserved holes on Bottom Cover and place it on Bottom Cover.
②Put Top Cover down to cover Raspberry Pi 4, and insert 3 M2.5*11 screws and 1 M2.5*4 screw into the holes. Then use the Allen key and a cross screwdriver to tighten the screws to fix Top Cover, Raspberry Pi 4 and Bottom Cover.
|
