Features
| Passive Cooler for Raspberry Pi 4 |
| Sheet metal + CNC cutting process, easy to install |
| Pre-installed with thermal conductive silicone |
|
Excellent cooling performance can effectively reduce the CPU temperature of Raspberry Pi 4
|
| All interfaces of Raspberry Pi 4 are accessible |
Specifications
| Cooling Performance | ||
| Test Device Configuration | Raspberry Pi 4 |
Raspberry Pi 4 + ED-Pi4PCOOLER
|
| Software Configuration |
CPU 4 cores running at full load via sysbench
|
|
| Ambient Temperature | 25℃ | |
|
Stable running temperature of CPU(℃)
|
74.4
|
59.2
|
|
Test Results: Under the environment of 25℃, when the device is running in a stable state, ED-Pi4PCOOLER can reduce the temperature of Raspberry Pi 4 by about 15℃, allowing the Raspberry Pi 4 CPU to run continuously at its maximum mains frequency (1800MHZ).
|
||
| Mechanical Characteristics | |
|
Dimensions
|
65mm x 56.5mm x 9.3mm |
| Material | Sheet Metal |
| Colour | Black |
| Weight | About 40g |
Document Download
| Datasheet Download |
| Testing Report Download |
Dimension Unit:mm
Order Information
| P/N: ED-Pi4PCOOLER |
|
Configuration: Passive Cooler for Raspberry Pi 4
|
| Packing List |
|
1 x ED-Pi4PCOOLER
1 x Accessory Kit (With 3 x M2.5*12 Screws and 3 x M2.5 Nuts)
|
Installation Schematic
|
Parts list:
|
||
|
NO.
|
Name | Quantity (PCS) |
| 1 | ED-Pi4PCOOLER | 1 |
| 2 | Raspberry Pi 4 (Not provided) | 1 |
| 3 |
M2.5*12 Screw
|
3 |
| 4 |
M2.5 Nut
|
3 |
|
Note:
- Raspberry Pi 4 is not included in the box, the following is intended as an installation illustration only.
- Before you start installing, please remove the White Protective Paper from thermal silicone in ED-Pi4PCOOLER.
- Before you start installing, please check whether the tops of 3 Nylon Posts in ED-Pi4PCOOLER are on the same level. If there are some tops that are higher than others, please press the higher tops into the mounting holes.
Steps: 
① Place the ED-Pi4PCOOLER on the Raspberry Pi 4 so that the 3 Nylon Post holes align with the 3 mounting holes on the Raspberry Pi 4.
② Place 3 M2.5 nuts under the 3 mounting holes of the Raspberry Pi 4, then insert 3 M2.5*12 screws into the 3 screw hole positions of the ED-Pi4PCOOLER, and use a screwdriver to tighten them clockwise to secure the ED-Pi4PCOOLER to the Raspberry Pi 4.
|
